The Best Guide to Night Vision Scope Installation

Are you searching for the best guide to night vision riflescope installation? Night vision devices enable you to aim efficiently during the night than when using your eyesight. In this post, we’ll look at 7 steps on mounting a night vision scope on your rifle.

1. Match the Bases and Rings

Most modern rifles are either tapped or predrilled for scope bases or grooved for the ideal mounting attachments. Ensure the mounting system you choose is the best fit for your weapon. Make sure the rings are of the right height and diameter for proper positioning of your scope.

Some types of scope rings will only fit certain types of scope bases, which means you should ensure the components match. The scope rings are available in varying heights, which may confuse you. The best way to choose is to ask the gun shop operator for advice.

2. Mount Bases

The best way to mount the scope is as low as possible on your rifle without the barrel being touched by the objective bell. It should allow for clearance at the eyepiece, which will ensure free operation of the bolt.

Most rings and bases are attached with screws by using wrenches/socket heads. Before you connect them, clean the attaching surfaces dry and clean. You should then apply a RUST PREVENTIVE OR COAT OF OIL. Make sure they are well aligned and that you aren’t aligning them in a backward way.

3. Lock Them Down

Apply a minimum drop of thread freezing compounds for maximum security. Tighten the screws for an even fit. If you choose to use rings, which attach the front base through a rotating socket system, avoid using the scope as a lever for pivoting the ring into its position. The best way is to use an object of similar diameter or wooden dowel.

4. Align Reticle

Once half of the bottom rings are in place, position your scope and tighten the ring’s top halves enough to enable the scope to rotate and move forth and back. Once your rifle is held level, you should turn the scope until the Reticle is precisely horizontal and vertical.

5. Adjust the Eye Relief

Position your scope well enough to ensure your eye is safe from any recoil. One rule you should use is to move it forward (about an inch) that you think it’s supposed to be.

6. Tighten the Screws

Check twice the scope’s position and ensure you tighten the ring screws. You can also tighten the screws to get even spacing among the ring halves.

7. Bore Sight

Using the right insertion pin of the caliber, which you’re using, insert a bore sight. You should then adjust the horizontal and vertical axis to your likely point of aim.

Summary

Using the best guide to (night vision scope) installation above, you should find it easier to install a night vision scope onto your rifle.